SurvCE Version1.50.008

Moderator: Carlson Support

SurvCE Version1.50.008

Postby Justin Brungard » Fri May 27, 2005 1:03 am

I installed the new version of SurvCE on monday and had a problem with it.
I use a Topcon GPT 8000 remote instrument. The other day when I went to
stakeout I tooked my BS and told the instrument to "set and read angle" and
after that process was done I went to stakeout the point. However, when I
went to stakeout I noticed that my instrument was not feeding my allegro
with real time information like it usually does. I found that the problem
was that the program had changed my equipment from the topcon 8000 remote to
the topcon APL1 which is why it would not communicate. I changed this and
took a BS three times and the same thing happened each time. Am I doing
something wrong?
Justin Brungard
 

Re: SurvCE Version1.50.008

Postby Barkley Hensley » Fri May 27, 2005 5:30 pm

Justin, you aren't doing anything wrong. I have been told that the
programmers are aware of this and are looking into it. I would
recommend that you reinstall 1.50.007 and use it until we post another
build of the software.



Justin Brungard wrote:
I installed the new version of SurvCE on monday and had a problem with it.
I use a Topcon GPT 8000 remote instrument. The other day when I went to
stakeout I tooked my BS and told the instrument to "set and read angle" and
after that process was done I went to stakeout the point. However, when I
went to stakeout I noticed that my instrument was not feeding my allegro
with real time information like it usually does. I found that the problem
was that the program had changed my equipment from the topcon 8000 remote to
the topcon APL1 which is why it would not communicate. I changed this and
took a BS three times and the same thing happened each time. Am I doing
something wrong?

Barkley Hensley
 


Return to SurvCE General

Who is online

Users browsing this forum: No registered users