Yes, we have done it several times since the initial problem and it seems to
be fine.We use a JettCE with bluetooth connection instead of cables, so our
original concern was that it was comm problem.
It's working OK now though.
Cables suck. Bluetooth rules...
--
Mike North, P.L.S.
TN #2370 AL #26008
True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419
www.truelinesurvey.com"John Roberson" <rls2669@charter.net> wrote in message
news:d9t81r$5ko$1@update.carlsonsw.com...
I performed a 2 point resection today with my Topcon GTS 3D hooked to my
Ranger running SurvCE 1.50.08.1
No problem
John
"Mike North, P.L.S." <mikenorthpls@comcast.net> wrote in message
news:d86pnp$or$1@update.carlsonsw.com...
We have installed the last SurveCE update. Up until this installation our
resection routine had been fine. Now we are having problems getting a
solution. We tried it on two different sets of points that were well
within tolerance.
Anyone else having this problem?
--
Mike North, P.L.S.
TN #2370 AL #26008
True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419
www.truelinesurvey.com