Carlson Software Forum

Posted: **Wed Jun 08, 2005 4:53 pm**

We have installed the last SurveCE update. Up until this installation our
resection routine had been fine. Now we are having problems getting a
solution. We tried it on two different sets of points that were well within
tolerance.

Anyone else having this problem?

--
Mike North, P.L.S.
TN #2370 AL #26008

True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419

www.truelinesurvey.com

Posted: **Fri Jun 10, 2005 7:54 pm**

Mike,

would you please let me know what instrument you are using, and what
data collector you are using. To date we have not been able to
duplicate the problem here. Please advise.

Mike North, P.L.S. wrote:

We have installed the last SurveCE update. Up until this installation our
resection routine had been fine. Now we are having problems getting a
solution. We tried it on two different sets of points that were well within
tolerance.

Anyone else having this problem?

Posted: **Wed Jun 29, 2005 8:29 am**

I performed a 2 point resection today with my Topcon GTS 3D hooked to my
Ranger running SurvCE 1.50.08.1

No problem

John

"Mike North, P.L.S." <mikenorthpls@comcast.net> wrote in message
news:d86pnp$or$1@update.carlsonsw.com...

We have installed the last SurveCE update. Up until this installation our
resection routine had been fine. Now we are having problems getting a
solution. We tried it on two different sets of points that were well
within tolerance.

Anyone else having this problem?

--
Mike North, P.L.S.
TN #2370 AL #26008

True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419

www.truelinesurvey.com

Posted: **Thu Jun 30, 2005 5:03 pm**

Yes, we have done it several times since the initial problem and it seems to
be fine.We use a JettCE with bluetooth connection instead of cables, so our
original concern was that it was comm problem.

It's working OK now though.

Cables suck. Bluetooth rules...

--
Mike North, P.L.S.
TN #2370 AL #26008

True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419

www.truelinesurvey.com

"John Roberson" <rls2669@charter.net> wrote in message
news:d9t81r$5ko$1@update.carlsonsw.com...

I performed a 2 point resection today with my Topcon GTS 3D hooked to my
Ranger running SurvCE 1.50.08.1

No problem

John

"Mike North, P.L.S." <mikenorthpls@comcast.net> wrote in message
news:d86pnp$or$1@update.carlsonsw.com...
We have installed the last SurveCE update. Up until this installation our
resection routine had been fine. Now we are having problems getting a
solution. We tried it on two different sets of points that were well
within tolerance.

Anyone else having this problem?

--
Mike North, P.L.S.
TN #2370 AL #26008

True Line Company, Land Surveyors
3328 Oak Burr Drive
Chattanooga, TN 37419

www.truelinesurvey.com

Carlson Software Forum

Resection

Resection

Re: Resection

Re: Resection

Re: Resection