Inverse

Moderator: Carlson Support

Inverse

Postby Toby B » Fri Jul 22, 2005 8:41 pm

In our software that we used previously ( TDS ) there was a Inverse - Byline
command that told you how far a point was off of a designated line between
two points. Is there a way to do this in SurvCE?
Toby B
 

Re: Inverse

Postby Terry Strickland » Sat Jul 23, 2005 4:04 am

Toby B wrote:
In our software that we used previously ( TDS ) there was a Inverse - Byline
command that told you how far a point was off of a designated line between
two points. Is there a way to do this in SurvCE?


It's under Cogo -> Point Projection -> Line (or Centerline file)
Terry Strickland
 


Return to SurvCE General

Who is online

Users browsing this forum: No registered users