Fixing a bad height of rod in raw data

Moderator: Carlson Support

Fixing a bad height of rod in raw data

Postby LloydL » Thu Feb 22, 2007 10:19 am

Does anyone know how to fix the elevations quickly on points shot with an
incorrect height of rod? I'm runnig SurvCE 1.65 on an Explorer 600+.

Thanks,


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##
LloydL
 

Re: Fixing a bad height of rod in raw data

Postby BSS » Thu Feb 22, 2007 5:59 pm

More information would be nice. Assuming I understand the question, if the
shots are all in, all you need to do is edit the rod height in the raw data,
(found under an HI tag) then re-import the raw data. Good luck and
hopefully you're not too far along.
BSS
 

Re: Fixing a bad height of rod in raw data

Postby ANDREW RIDDLE » Fri Feb 23, 2007 5:32 am

To Fix a bunch of heights easily, you can go to tranformation under cogo, i
believe and type the diff in rod height under the delta, like if the rod is
4 ft and it was supposed to be 6 ft then you need to enter -2.0 and a point
group such as 1000-1012 and there are options such as overwrite existing
points, put points in new file or renumber points.
"LloydL" <lel1956@charter.net> wrote in message
news:erj95p$joo$1@update.carlsonsw.com...
Does anyone know how to fix the elevations quickly on points shot with an
incorrect height of rod? I'm runnig SurvCE 1.65 on an Explorer 600+.

Thanks,


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##
ANDREW RIDDLE
 


Return to SurvCE General

Who is online

Users browsing this forum: No registered users