Carlson Software Forum

Be on the lookout when slope staking from roads module in 2.0.
The program is not returning the correct location when on the left side of
the template.if your using an offset value from the pivot point, it can be
loaded as a negative value and the program seems to return the correct
location.

also, user defined slope will not override the design template cut/fill
slope ratio.this is applicable on both sides of the template.

Hopefully, the programmers will read this and provide an answer.



##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##