Carlson Software Forum

Hi all,
I stored my base point (after upgrading to 2.0) on a point that I had
previously did a static survey in SurvCE 1.6x and configured "from new
position > Enter Grid coords" (used the point number in the file). The
new base point that I stored was 0.348' higher (or 106.1 mm, exactly the
L1 phase offset of the Hipers).
What gives? Was the antenna height wrong to begin with, or is it wrong
now?????
terry

If you store the base location from the monitor > reference tab, you
must set the antenna type (to HIPER_LITE in this case). The default is
none. That's why I came up with a 0.35' difference. This step is a
little different from previous versions, didn't have to do this then.
terry