Topcon GR-3 and SurvCE 2.02

[DownunderDave]

I have the GR-3 GNSS system by Topcon using an FC2000 data collector. I
was getting screen freezing in V2.00 after SurvCE would post an autonomous
message. I upgraded to 2.02 but the problem is still there. My reseller
recommended to change the configuration to 115200 baud on the radio
setting but you can only do this if you select generic or cable instead of
internal UHF. I tried this but it was no better than using 38400 baud - I
still get the drop out and have to close SurvCE and restart to
re-establish B/T connection to the receiver. Anyone else having this
problem?



##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##