Stake Out :Point in Direction Option

Moderator: Carlson Support

Stake Out :Point in Direction Option

Postby ColC » Tue May 25, 2010 10:34 pm

There is a neat option in the Stake Option which if you are unaware of could cause a problem. In the Stake Out points screen if you select point in direction and go down to the box H.Distance you can use the left/ right to select H.offset instead. I could not see a mention in the manual and the only indication of its existence is a > above the box. The > is used extensively by the TDS software but it highlights when you drop in the box.

This discovery caused my surveyor some stress when trying to project an offset a small distance onto a brick wall. It was only that he was observant enough to see on the screen that the calculated point was offset to the line and not a production of the line. It took a email to support to discover the existence of the option.
ColC
 
Posts: 204
Joined: Mon Oct 29, 2007 9:35 am
Location: Toronto,NSW Australia

Return to SurvCE General

Who is online

Users browsing this forum: No registered users