How to connect a Lasercraft Contour Rangefinder v Bluetooth
Posted: Fri Jun 25, 2010 4:34 amfound the answer just after writing the message,so here goes:
- the internal bluetooth module only talks at 4800 baud, so set the Contour and SurvCE to that speed
- set-up a serial port for the Bluetooth connection (1234) on the controller
- Use the lasercraft protocol in SurvCE (and in the laser) and pick the com port that you've allocated above.
- the internal bluetooth module only talks at 4800 baud, so set the Contour and SurvCE to that speed
- set-up a serial port for the Bluetooth connection (1234) on the controller
- Use the lasercraft protocol in SurvCE (and in the laser) and pick the com port that you've allocated above.