How to connect a Lasercraft Contour Rangefinder v Bluetooth

Moderator: Carlson Support

How to connect a Lasercraft Contour Rangefinder v Bluetooth

Postby paulkoren » Fri Jun 25, 2010 4:34 am

found the answer just after writing the message,so here goes:

- the internal bluetooth module only talks at 4800 baud, so set the Contour and SurvCE to that speed
- set-up a serial port for the Bluetooth connection (1234) on the controller :!:
- Use the lasercraft protocol in SurvCE (and in the laser) and pick the com port that you've allocated above. :!:
paulkoren
 
Posts: 9
Joined: Sun Dec 09, 2007 11:30 pm
Location: Sydney, Australia

Return to SurvCE General

Who is online

Users browsing this forum: No registered users