Page 1 of 1

Northwest Instruments NTS02S and SurvPC v6

PostPosted: Thu Oct 04, 2018 6:31 pm
by archaeoguy
Hi all,

Does anyone have any experience running a Northwest Instruments NTS02s total station with SurvPC v6 via bluetooth? I am getting an error after I send a command saying "the data cannot be read." The error is only limited to bluetooth, however. When I connect via cable then everything works fine. I don't know how the bluetooth communication would be a problem and so I do not know how to fix this issue. Any ideas would be greatly appreciated.

Thanks,

Erich

Re: Northwest Instruments NTS02S and SurvPC v6

PostPosted: Fri May 06, 2022 12:31 am
by kcormier
Hi there, I could never get the Northwestern instrument to connect to serve PC version six. I also have a Valpar which is a brother to the Northwestern instruments and again cannot get them connect to survPC version six. I contacted Carlson about the situation but they were unable to help. However I would like to know your settings for the Northwestern instrument using it via the cable.