Page 1 of 1

Prompt when I start a new line without ending the previous

PostPosted: Fri Aug 09, 2019 3:28 pm
by CMB
Hi there.
Note: I have changed my special code begin line to B and end line to E. When I start a new line, "SW2 B", if I did not end the last SW2 line with an E, SurvCE prompts me asking if I want to end the previous SW2, or connect it or whatever. I am very good at keeping my lines in check in my head, so I was wondering if I can turn off this prompt. If my last code was "SW2 E", I do not get this prompt.

Thank you.