Carlson Software Forum

I've been getting the following in a couple drawings when I hit save:

Internal Warning 2: dictionary entry INI\tri4\InteriorLengthEdit wrong type 40
Internal Warning 2: dictionary entry INI\tri4\CntrIntervalEdit wrong type 40
Internal Warning 2: dictionary entry INI\tri4\InteriorLengthEdit wrong type 40
Internal Warning 2: dictionary entry INI\tri4\CntrIntervalEdit wrong type 40

I can open in vanilla autocad and it saves with no warnings. Opening again with Carlson gives the warnings again.

Ideas or suggestions?

I see similar messages using Carlson with the Intellicad engine also. I haven't taken the time to write up a bug report yet. If you hear anything please share