blocks?

[Streek]

Carlson 2013 w/ embedded ACAD


How do I show a list of blocks in the current drawing?

In ACAD it was BLOCKenter ? it took 2 seconds.

[Dent Cermak]

Your Surv.pgp file is evidently set to give you the option window on the block command. So, try entering -block on the command line. After the "minus" block command you will get ENTER BLOCK NAME. Enter the ?. Then at ENTER BLOCKS TO LIST enter *.
Note this will also include any blocks that you have listed in your *.dwt file, so for an accurate lise, purge all of the unused block definitions before using -block.

[Streek]

Thanks DC, that did it!

[Nava Ran]

Draw>Insert will show you the list of blocks