Page 1 of 1

Interpolating Between Points

PostPosted: Tue Jan 08, 2019 2:26 pm
by DedricJ
Is there a way in Carlson Civil 2019 to interpolate elevations of a curb or any line between two known point elevations? The way I am being instructed to do this seems counterintuitive to proficiency. It would be easier/simpler if there was a command or a way to just change a line into a 3D polyline and have the elevation along a cur interpolate as opposed to having to delete sections of line and run a 3D polyline command and tell it to interpolate between points. Thanks for any help.