Carlson Software Forum

is there a way to automate the cut/fill balance.

what i am looking for is to give some parameters (max grade, curve data- speeds, cross section, cut fill ratio) and have the program "design" the road with least mass haul.

possible?

GeoTrek,

I don't think we have anything for this yet. I will make sure it is on the wish list. RoadNET is set up to let you edit as you go but you still have to do the editing.

Until a more automated solution becomes available, perhaps the steps listed in my reply at http://update.carlsonsw.com/phpBB2/viewtopic.php?t=2031 might suffice?

Thanks for sharing

computer