Jon,
I have notified the programmers of this problem. This should be
corrected in the next build.
Barkley Hensley, P.L.S.
Technical Support Manager
Carlson Software
-----Original Message-----
From: Jon Baker [mailto:jonathanjbaker@hotmail.com]
Posted At: Tuesday, May 22, 2001 5:02 PM
Posted To: dtm-contour
Conversation: BREAK CONTOURS... AGAIN...
Subject: BREAK CONTOURS... AGAIN...
I change "break contour at label insertion" so that it is UN-checked in
the
configure survcad.. but I open a drawing and it reverts to breaking
them..
why? can I change this setting with in a lisp or dcl file or some
file... so
it never turns itself back on... please I beg of you guys at survcad to
help
me with this....
--
Jonathan Baker
R&R Engineers-Surveyors, Inc.
Denver, Colorado 80246
http://www.rrengineers.com/
Phone: 303-753-6730 ext 15
________________________