Carlson Software Forum

In CES, Points>Renumber points command just messed up on me. I tried to
renumber points by 1. Some renumbered with attributes changing, some
renumbered without attribute changing and some didn't get renumbered at
all
(just point on screen and nothing in the CRD file goes to that point).

Use the coordinate file utilites renumber if you need to renumber
points, I
haven't seen that one mess up yet.

Have any bugs been found in this?

Jason

"Jason" <jbly@marshandlegge.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59F7C0@WEBSERVER...

In CES, Points>Renumber points command just messed up on me. I tried
to
renumber points by 1. Some renumbered with attributes changing, some
renumbered without attribute changing and some didn't get renumbered
at

all

(just point on screen and nothing in the CRD file goes to that point).

Use the coordinate file utilites renumber if you need to renumber
points,

I

haven't seen that one mess up yet.

I cannot duplicate what you describe. Can you provide the CRD file and
drawing where this happens?

--
Randall McSwain
Carlson Software
http://www.carlsonsw.com


"Jason" <jbly@shentel.net> wrote in message

Have any bugs been found in this?