Interval on Polyline

Moderator: Carlson Support

Interval on Polyline

Postby Jack Goodrich » Thu Jul 05, 2001 7:25 pm

The update doc states that the "Interval along entity" program will
start
the points near the end of the polyline that you pick now, but this is
not
happening in my program. It still depends on the direction in which the
polyline was created. I am using AutoCAD 2000 SP2, with SurvCadd CES
build
3-13-2001. Of course I am very thankful for the "reverse polyline"
routine.

Thanks,
Jack
Jack Goodrich
 

Re: Interval on Polyline

Postby Randall McSwain » Wed Jul 11, 2001 9:50 pm

Jack,
It appears that the routine works correctly unless you tell it to
create
a point at the start. In that case, it puts the start point at the
beginning
of the polyline instead of end point nearest to your pick point. I will
report this problem. Keep an eye out for this fix in a future build.

Thanks!


--
Randall McSwain
Carlson Software
http://www.carlsonsw.com


"Jack Goodrich" <jwg@sec-civil.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE590105FA@WEBSERVER...
The update doc states that the "Interval along entity" program will
start
the points near the end of the polyline that you pick now, but this is
not
happening in my program. It still depends on the direction in which
the
polyline was created. I am using AutoCAD 2000 SP2, with SurvCadd CES
build
3-13-2001. Of course I am very thankful for the "reverse polyline"
routine.

Thanks,
Jack
Randall McSwain
 


Return to Survey

Who is online

Users browsing this forum: No registered users