Interval on Polyline
Posted: Thu Jul 05, 2001 7:25 pm
The update doc states that the "Interval along entity" program will
start
the points near the end of the polyline that you pick now, but this is
not
happening in my program. It still depends on the direction in which the
polyline was created. I am using AutoCAD 2000 SP2, with SurvCadd CES
build
3-13-2001. Of course I am very thankful for the "reverse polyline"
routine.
Thanks,
Jack
start
the points near the end of the polyline that you pick now, but this is
not
happening in my program. It still depends on the direction in which the
polyline was created. I am using AutoCAD 2000 SP2, with SurvCadd CES
build
3-13-2001. Of course I am very thankful for the "reverse polyline"
routine.
Thanks,
Jack