Carlson Software Forum

When I start a new drawing, the angle unit type is surveyor's units.
After
executing a traverse under cogo, the units angle type changes to
radians.
Any ideas why?

AutoCAD Map R4
SurvCadd CES

John Gordon
Alphatec Surveyors, Ltd.

John,
I cannot repeat this. Are you sure it's the Traverse command making
this change and not another command? It would be helpful if you could
provide a step by step procedure that you use to make this happen.
Please include the command line history also.

--
Randall McSwain
Carlson Software
http://www.carlsonsw.com


"John Gordon" <pavidman1@aol.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59012858@WEBSERVER...

When I start a new drawing, the angle unit type is surveyor's units.
After
executing a traverse under cogo, the units angle type changes to
radians.
Any ideas why?

AutoCAD Map R4
SurvCadd CES

John Gordon
Alphatec Surveyors, Ltd.

I'll get something to ya soon Randall.
"Randall McSwain" <rmcswain@carlsonsw.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59012888@WEBSERVER...
John,
I cannot repeat this. Are you sure it's the Traverse command making
this
change and not another command? It would be helpful if you could provide
a
step by step procedure that you use to make this happen. Please include
the
command line history also.

--
Randall McSwain
Carlson Software
http://www.carlsonsw.com


"John Gordon" <pavidman1@aol.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59012858@WEBSERVER...

When I start a new drawing, the angle unit type is surveyor's units.
After
executing a traverse under cogo, the units angle type changes to
radians.
Any ideas why?

AutoCAD Map R4
SurvCadd CES

John Gordon
Alphatec Surveyors, Ltd.