Hello all,
I have had a few files lately that have lines with elevations over
2,000,000. This elevation is viewed in the "properties" window for the
line. A funny thing happens though when I view it in "3d view" (command:
cube). The lines with elevations of over 2,000,000 line up perfectly with
the adjacent lines with elevations of around 1500. This causes problems
when I try to nearjoin my lines. Since they are not technically the same
elevation, they will not join. I am also not sure what will happen with
these files when I import them into my earthworks software.
Has anyone experienced similar problems? Is there a way to fix this?
--
Matt Timion
Earthwork Calculation Services