Hello all,
I am working on creating a DTM for grade control for a client of ours. It
turns out that the original engineer used INCHES as units instead of FEET.
This is causing major problems mainly b/c the coordinate system is 12 times
too large (ie, coordinates for this job are N 23 Million and E 75 Million,
clearly not in North America!)
Anyway, I've tried to use the SCALE command and scaled the job 1/12, but it
is also scaling the elevations. I've tried using the ALIGN command, but am
finding the same problem.
Is there a way to scale the drawing to 1/12 while keeping the elevations in
tact?
Any possible solutions would be great. Please be as detailed as possible in
any responses!
--
Matt Timion
Earthwork Calculation Services