"Dan Grubb" <dangrubb@zande.com> wrote in message
news:bidgn1$2cj$1@update.carlsonsw.com...
We just got our first seat of xml2 installed so we can test it for any
bugs.
I have a problem when using the configure Survcadd command. The problem is
that when I pick the DTM-Contour module option in Survcadd Config the
computer locks up completely. Has any one else had this problem?
The machine it is on is a p4 2gig with 512 meg of ram.
thx,
Dan Grubb
Now that you mention it, it most certainly does!
I have had another couple of lockups too. I have not documented them all.
I am waiting for repeats.
One that is reproducable is:
While in the INPUT/EDIT PROFILES dialog, I entered a vertical curve
length that was too big. A warning dialog appeared that could not be
satisfied, thus locking up the session.
Terry Scanlon