by mpossjr » Tue Dec 21, 2010 3:59 pm
I noticed that some of my options do not work either.
My problem was that some of the command buttons were not set to the correct command prompt. I had to manually change each command button to run the correct command prompt.
There may be an easier solution but this is what I did.
Once you change the command information and click apply this can not be undone unless you manually change it back!
You can search for the correct command using the help menu.
Once you find the correct command you can right click on any toolbar and click customize.
At the top you can look for the button or command. You can change the macro to ^C^C*****
(replace the ***** with the correct command)
Click apply and ok
You can also add any command to any toolbar and even draw your own toolbar symbol to match the new command.
I hope this helps.