Curve Table Blocks

Moderator: Carlson Support

Curve Table Blocks

Postby Smurphy » Tue Feb 08, 2011 1:47 pm

Sometimes a curve table is so long that I find the need to split it into two columns. In 2011 the entire curve table is now a single block and cannot be edited. I can uncheck the box "Use Table Entity" in the Curve Table Defaults but then the curve table prints without any framing. I would like to see the curve table display as individual blocks for each line with the framing intact as was the standard in earlier versions.
Steve
Smurphy
 
Posts: 14
Joined: Mon May 11, 2009 5:28 pm

Postby site admin » Tue Feb 08, 2011 2:10 pm

Please be sure you are running the latest build of the 2011 software and if it is still giving you trouble, copy your report and send it in to support@carlsonsw.com along with a sample drawing where it is not drawing the table frames...

Thank you.
Brian Harris
Carlson Software
Technical Support
606-564-5028
support@carlsonsw.com
site admin
Site Admin
 
Posts: 332
Joined: Wed Nov 21, 2007 4:40 pm
Location: Maysville KY


Return to Survey

Who is online

Users browsing this forum: No registered users

cron