Carlson Software Forum

I am working on a street improvement project, where the curb & gutter is being left in place. The C&G has some issues and does not have good horizaontal or vertical alignment. I want to establish my template at the centerline and tie the Edge of Pavement to either an alignment or a 3D polyline at the Lip of Gutter. The short and long: the outside edge of pavement is not a consistent grade above/below the centerline, nor is it a consistent distance from the centerline. I want the program to tell me what my cross-slope is at any given station. What is the best way to accomplish this?

Thank you.

Nate,

We will handle this via the Case 53367 that you emailed to us.

Bharris

Ok, thanks.