Carlson Software Forum

I went to triangulate and contour.
After the OK button on the popup box, I was not given a pick box to select each node/point.
Is there something wrong in my selection of triangulate & contour popup?

Thank you for your help.

Are you using intellicad or AutoCAD?

Hi Pin.
I am using Intellicad.
Thanks for reply.

It seem that my contour is working now.
I just tried many different options.
Not sure if I didn't see the command line asking me to pick or it wasn't there before. Still, my pick box is not by itself, but with cross hair present as if I was doing something woring with the selections on my popup box. Usually, when asked to pick a point/node, the cross hair wouldn't be present and only the box would be there. Just confused me with the cross hair present.

Try changing the colors of the cross hairs and the pick box to see which is actually showing up. To set you cross hairs and pickbox color see:

Setteings>Intellicad options>cross hairs tab

also check out the other tabs in this box, this is where you change the background color among other stuff.

Thanks for help.
I tried changing various things.
But not what I was looking for.
Maybe in conflict with intellicad options with AutoCad options.

I shall just work with what it is.

Thank you for your time.