TRIANGULATE & CONTOUR

Moderator: Carlson Support

TRIANGULATE & CONTOUR

Postby AlbertCalifornia » Thu Sep 29, 2011 3:32 pm

I went to triangulate and contour.
After the OK button on the popup box, I was not given a pick box to select each node/point.
Is there something wrong in my selection of triangulate & contour popup?

Thank you for your help.
AlbertCalifornia
 
Posts: 5
Joined: Thu Sep 15, 2011 9:31 pm

Postby Pin Cushion » Thu Sep 29, 2011 4:54 pm

Are you using intellicad or AutoCAD?
I was blind... but now I see with Carlson.
Pin Cushion
 
Posts: 53
Joined: Wed Sep 21, 2011 2:57 pm
Location: Space

Postby AlbertCalifornia » Thu Sep 29, 2011 5:16 pm

Hi Pin.
I am using Intellicad.
Thanks for reply.

It seem that my contour is working now.
I just tried many different options.
Not sure if I didn't see the command line asking me to pick or it wasn't there before. Still, my pick box is not by itself, but with cross hair present as if I was doing something woring with the selections on my popup box. Usually, when asked to pick a point/node, the cross hair wouldn't be present and only the box would be there. Just confused me with the cross hair present.
AlbertCalifornia
 
Posts: 5
Joined: Thu Sep 15, 2011 9:31 pm

Postby Pin Cushion » Thu Sep 29, 2011 5:35 pm

Try changing the colors of the cross hairs and the pick box to see which is actually showing up. To set you cross hairs and pickbox color see:

Setteings>Intellicad options>cross hairs tab

also check out the other tabs in this box, this is where you change the background color among other stuff.
I was blind... but now I see with Carlson.
Pin Cushion
 
Posts: 53
Joined: Wed Sep 21, 2011 2:57 pm
Location: Space

Postby AlbertCalifornia » Thu Sep 29, 2011 6:07 pm

Thanks for help.
I tried changing various things.
But not what I was looking for.
Maybe in conflict with intellicad options with AutoCad options.

I shall just work with what it is.

Thank you for your time.
AlbertCalifornia
 
Posts: 5
Joined: Thu Sep 15, 2011 9:31 pm


Return to Survey

Who is online

Users browsing this forum: No registered users