How to calculate a "point in direction?"

Moderator: Carlson Support

How to calculate a "point in direction?"

Postby dbolt » Tue Nov 01, 2011 6:54 pm

Hello,
I am new to the Carlson and Intellicad software, and am haveing trouble with the simplest of tasks. Could someone enlighten me on how to calculate a point in direction?
dbolt
 
Posts: 3
Joined: Tue Nov 01, 2011 6:43 pm

Postby site admin » Mon Nov 07, 2011 1:49 pm

If you have not received any assistance on this matter, please contact Carlson Technical Support @ support@carlsonsw.com or by calling 606-564-5028
site admin
Site Admin
 
Posts: 332
Joined: Wed Nov 21, 2007 4:40 pm
Location: Maysville KY

Postby Dent Cermak » Mon Nov 07, 2011 3:20 pm

Points can be located by direction and distance two ways. You can also draw your lines by angle/distance and then put points at the PI's.
Look under the COGO tab. If you wish to establish points by direction/distance, you can do that using the TRAVERSE option OR you can locate points using the LOCATE BY BEARING/ANGLE.
Either way will locate your points for you. Each option will allow you to use bearings, azimuths or turned angles.
But then, I imagine you have already figured this on out. I just saw it, but I'm usually the last one to the party anyway. :oops:
Dent Cermak
 
Posts: 486
Joined: Fri Mar 28, 2008 6:54 pm
Location: Clinton, MS


Return to Survey

Who is online

Users browsing this forum: Google [Bot]