WRITING A ROUTINE IN A TOOLBAR

Moderator: Carlson Support

WRITING A ROUTINE IN A TOOLBAR

Postby jbaldeo » Thu Nov 15, 2012 9:08 pm

Could anyone explain how I can write a routine in a toolbar to draw a leader with a curve using just 3 picks ? Presently I would have to select Dimleader, pick the first and second point, then select F (Format), then enter, then select SP (Spline), then enter, then pick the third point, then enter and enter again and then select N (None) and then enter to complete. I am using Carlson 2013 w/icad 7
JB1
JB1
jbaldeo
 
Posts: 51
Joined: Wed Jul 25, 2012 1:45 pm

Re: WRITING A ROUTINE IN A TOOLBAR

Postby cfm » Thu Nov 15, 2012 9:47 pm

Have a look at pull down menu DRAW/LEADER
cfm
 
Posts: 22
Joined: Wed Mar 11, 2009 10:06 pm
Location: Townsville, Queensland, Australia

Re: WRITING A ROUTINE IN A TOOLBAR

Postby jbaldeo » Fri Nov 16, 2012 2:17 pm

sorry those does not help
JB1
jbaldeo
 
Posts: 51
Joined: Wed Jul 25, 2012 1:45 pm

Re: WRITING A ROUTINE IN A TOOLBAR

Postby gskelhorn » Sat Nov 17, 2012 1:00 am

I posted an answer in Intellicad General forum...
gskelhorn
 
Posts: 197
Joined: Tue Nov 03, 2009 12:56 am

Re: WRITING A ROUTINE IN A TOOLBAR

Postby jbaldeo » Tue Nov 20, 2012 7:40 pm

it worked!! thank you, I needed the user input and \ was it, thanks again
JB1
jbaldeo
 
Posts: 51
Joined: Wed Jul 25, 2012 1:45 pm


Return to Survey

Who is online

Users browsing this forum: No registered users