WRITING A ROUTINE IN A TOOLBAR
Posted:
Thu Nov 15, 2012 9:08 pmby jbaldeo
Could anyone explain how I can write a routine in a toolbar to draw a leader with a curve using just 3 picks ? Presently I would have to select Dimleader, pick the first and second point, then select F (Format), then enter, then select SP (Spline), then enter, then pick the third point, then enter and enter again and then select N (None) and then enter to complete. I am using Carlson 2013 w/icad 7
JB1
Re: WRITING A ROUTINE IN A TOOLBAR
Posted:
Thu Nov 15, 2012 9:47 pmby cfm
Have a look at pull down menu DRAW/LEADER
Re: WRITING A ROUTINE IN A TOOLBAR
Posted:
Fri Nov 16, 2012 2:17 pmby jbaldeo
sorry those does not help
Re: WRITING A ROUTINE IN A TOOLBAR
Posted:
Sat Nov 17, 2012 1:00 amby gskelhorn
I posted an answer in Intellicad General forum...
Re: WRITING A ROUTINE IN A TOOLBAR
Posted:
Tue Nov 20, 2012 7:40 pmby jbaldeo
it worked!! thank you, I needed the user input and \ was it, thanks again