Points and elevation display

Moderator: Carlson Support

Points and elevation display

Postby nwonnell » Tue Jun 18, 2013 6:23 pm

Am very new to Carlson Survey and am trying to get as much info as I can without bothering people. However, I cant find out how to get the elevations to show on my imported points from an ASCII file. I have imported several points into a .dwg and the elevation does not show up although there is one in the .crd file. I have created many points manually and the elevation shows for those points.

On another note is there anything out there as far as a tutorial about points, the symbols, blocks and attributes. I like the micromanagement that Carlson has on its points but not accustomed to it as of yet. I would like to just have one layer that contains everything for a point...being the sumbol, desc, pt no., elev. Is that possible?

Thanks in advance,
nwonnell
 
Posts: 4
Joined: Tue Jun 18, 2013 5:20 pm
Location: Batesville

Re: Points and elevation display

Postby Nava Ran » Wed Jun 19, 2013 6:18 am

Nava Ran
 
Posts: 151
Joined: Tue Dec 18, 2007 3:12 pm
Location: Israel

Re: Points and elevation display

Postby Dent Cermak » Wed Jun 19, 2013 12:39 pm

Also check out the training films on this web site. They cover most everything if you dig deep enough.
Dent Cermak
 
Posts: 486
Joined: Fri Mar 28, 2008 6:54 pm
Location: Clinton, MS

Re: Points and elevation display

Postby nwonnell » Wed Jun 19, 2013 8:59 pm

Thanks for the links and words.
nwonnell
 
Posts: 4
Joined: Tue Jun 18, 2013 5:20 pm
Location: Batesville


Return to Survey

Who is online

Users browsing this forum: No registered users