Page 1 of 1

Points and elevation display

PostPosted: Tue Jun 18, 2013 6:23 pm
by nwonnell
Am very new to Carlson Survey and am trying to get as much info as I can without bothering people. However, I cant find out how to get the elevations to show on my imported points from an ASCII file. I have imported several points into a .dwg and the elevation does not show up although there is one in the .crd file. I have created many points manually and the elevation shows for those points.

On another note is there anything out there as far as a tutorial about points, the symbols, blocks and attributes. I like the micromanagement that Carlson has on its points but not accustomed to it as of yet. I would like to just have one layer that contains everything for a point...being the sumbol, desc, pt no., elev. Is that possible?

Thanks in advance,

Re: Points and elevation display

PostPosted: Wed Jun 19, 2013 6:18 am
by Nava Ran

Re: Points and elevation display

PostPosted: Wed Jun 19, 2013 12:39 pm
by Dent Cermak
Also check out the training films on this web site. They cover most everything if you dig deep enough.

Re: Points and elevation display

PostPosted: Wed Jun 19, 2013 8:59 pm
by nwonnell
Thanks for the links and words.