Page 1 of 1

Bearing Assoc

PostPosted: Tue May 05, 2015 2:42 pm
by Ladyhawk21
how can i un associate bearings with the lines? if i change the color of a property line it changes all the bearings to the color i just changed the line to?

Thanks

Re: Bearing Assoc

PostPosted: Wed May 06, 2015 3:09 pm
by Streek
hmmmm,
mine doesn't

under ANNOTATE
ANNOTATE DEFAULTS
ANGLE (tab)
ANGLE LAYER
i have mine set to TEXTM, it has no association to the line
:|



2013 carlson w/embedded ACAD

Re: Bearing Assoc

PostPosted: Wed May 06, 2015 7:12 pm
by Ladyhawk21
this is how mine is set up- what do i need to change

Re: Bearing Assoc

PostPosted: Thu May 07, 2015 5:30 pm
by Dent Cermak
Evidently you have your bearings and line work set to go to the same layer.
Create a layer called BRNG-TXT and set the color you want. Then assign the annotations to the TXT layer.
Then changing the properties of the linework will have no effect on your labels.

Re: Bearing Assoc

PostPosted: Tue May 12, 2015 3:38 pm
by Ladyhawk21
no linework goes on property bearings go to 0-Bearings

Re: Bearing Assoc

PostPosted: Wed May 13, 2015 12:31 am
by Dent Cermak
OK, next SWAG...... go to the Carlson Configure under the Settings tab. Click on the General Settings radio button. Look on top right side of the menu for Object Linking. Try unchecking the box next to Link Labels with linework.

Re: Bearing Assoc

PostPosted: Tue Jun 02, 2015 4:25 pm
by Ladyhawk21
ok i will give that a try: thanks