Annotation Errors????

Moderator: Carlson Support

Annotation Errors????

Postby Ryan Riley52 » Fri Oct 02, 2015 7:30 pm

I recently was doing static equipment Asbuilts and found an elevation Annotation label different from the CRD by a tenth. I reloaded the point and it still came up a tenth higher than what was in the CRD. I checked the raw data file from the data collector and it was right. I then copied the point and pasted in a different spot on the drawing and it came out right. I deleted everything in the area of the point (a very large area) and put the copied point back and it annotated the wrong elevation again. I used another department computer and drew the point and it annotated correctly. I have seen errors in 3d circles and check them regularly, but has anyone else seen this or know of a setting? We recently had a power outage and it seems Carlson doesn't like being shutdown this way. Any help is much appreciated.
Ryan Riley52
 
Posts: 3
Joined: Tue Jun 30, 2015 3:30 pm
Location: U.S.A.

Return to Survey

Who is online

Users browsing this forum: MSN [Bot]