Page 1 of 1

dwg to IntelliCad

PostPosted: Fri Oct 23, 2015 10:37 pm
by mark baker
While I was gone on vacation, one of my employees must have accidentally changed all my dwg drawings to intellicad drawings. Will this affect the drawings and can I change them all back to dwg drawings? I have Carbonite Backup so I could replace the files. Thanks.

MB

Re: dwg to IntelliCad

PostPosted: Mon Nov 09, 2015 6:28 pm
by Dent Cermak
A dwg is a dwg. There is NO differance between the two.
Open that drawing on any computer with only AutoCad on it and you will see what you are used to.
Actually there is no way to "convert" a dwg to a Intellicad dwg, That's just the labeling assigned by your software,
Take that same file and open it on an OEM version of Carlson and you will see "Carlson dwg" under file type.

Re: dwg to IntelliCad

PostPosted: Mon Nov 09, 2015 8:49 pm
by mark baker
Thanks.