Page 1 of 1

Field to Finish Issue

PostPosted: Tue Jan 05, 2016 8:42 pm
by SOVASurveyor
New to Carlson, coming from Civil3D at new firm.
Setting up Field to Finish code set. When ASCII file is imported, the linework and point description are on the correct layer. However, the point node is not. Attached below are pics of the result. Hopefully this is something simple. Thanks in advance.

Re: Field to Finish Issue

PostPosted: Fri Jan 08, 2016 12:18 am
by Dent Cermak
Once you have run field to finish and have all of your points, lines and symbols in your drawing, do a "Point Erase", "N" for number, "ALL" on next selection, DO NOT erase points from coordinate file and then yes to final question. Now you should have all your lines and symbols, etc.. Now run "Draw/Locate Points" and select "Draw All".
Also, under Settings check to see how you have you poi8nt options set to use point blocks. (Make sure too that the point descriptors are set up in your *.fld file. Undefined codes tend to come in with the nodes all wonky.)
That should solve your issues.