Page 1 of 1

F2F Linetypes

PostPosted: Mon Nov 20, 2017 12:28 am
by wcsurvey
I am setting up my F2F files. When I process data through F2F the linetypes are not showing up on the screen. But when I draw a standard line using the Draw Line command the linetypes show up. Even when I try to match properties of the two lines (that are on same layer) the line drawn by F2F remains a solid line. Any thoughts?

Re: F2F Linetypes

PostPosted: Tue Nov 21, 2017 7:52 pm
by Dent Cermak
Two possibilities:

(1) Somewhere you have your F2F linetypes defaulting to "continuous".

(2) The solid white lines are 3D polyline breaklines. Check your setups and see if you have one set to "Draw 2D and 3D lines".

Re: F2F Linetypes

PostPosted: Fri Aug 03, 2018 1:27 pm
by sherwood surveying
make sure this setting is 'off', 3d polylines will not show linetypes.