Page 1 of 1

Layer Lock

PostPosted: Thu Dec 14, 2017 10:45 pm
by napu671
Hafa Adai All,
Im new to this forum not sure is this the place to post. We been use Carlson software with intellicad for the last 8years and just upgraded to "2017". The issue im experience is " when i go to Lock a layer the image is removed". I know that when you Lock a layer it is ghosted but the image is still visible. The question is there a setting that needs to be reset or changed?

DLM, Guam

Re: Layer Lock

PostPosted: Fri Dec 15, 2017 3:56 pm
by Dent Cermak
I am not on the Intellicad version but the solution should be the same . Under the "Settings" tab there should ba an "Intellicad Options" selection. Click on that and look for the "Display" tab. There should be a slider for "Fade Control". Try changing that setting until you get what you need.

Re: Layer Lock

PostPosted: Tue Dec 19, 2017 1:27 am
by napu671
Dent, thank you for your response..I did try your suggestion still getting the same results. is there a setting just for the Layers? When i lock a layer it completely removes it as if you were freezing or turn off the layer.