Page 1 of 1

MTEXT editing

PostPosted: Fri Mar 08, 2019 3:48 pm
by FieldstoneSurvey
Been using Carlson for 10 years, just switched to IntelliCAD 2019 and have only one issue.
When selecting mtext to edit, the text is vertically spread down the screen, making it hard to find, almost as if a large 'line spacing' factor had been set.
I cannot find a setting a change how this is displayed.
I open the same drawing in Carlson OEM 2018 and all the mtext stays together.
If I could post screen shots....

For example, rather than:
N/F Murphy
Map 34, Lot 12
BK 12356/365

I get:

N/F Murphy









Map 34, Lot 12









BK 3213521/32132

Re: MTEXT editing

PostPosted: Fri Mar 08, 2019 7:38 pm
by FieldstoneSurvey
Well, that was quick.

I sent an email to Carlson Support at 2:13pm; by 2:22pm they had gotten back to me with a patch for IntelliCAD 2019 64-bit that solved the problem.