Page 1 of 1

edit multiple pt attributes stopped working

PostPosted: Wed Sep 18, 2019 12:16 pm
by MartinaLaw
Good Morning :) I have been using Carlson for about 10 months now (after years of Civil 3D). Until last week, I was able to use the edit multiple pt attributes command with success, but now, when I close the dialog window after making changes to attributes, the edits are not applied to the points. Any ideas? Thanks in advance :)

Re: edit multiple pt attributes stopped working

PostPosted: Sat Sep 21, 2019 1:30 pm
by gskelhorn
Initial guesses...

First, is the program identifying the plotted point entities in the drawing as Carlson points? If you run EDITPNT and select one of the points does the typical Edit Point dialog open?
editpnt.PNG


Second, when you run the EDITPNT command, note the coordinate file the point is associated with. Is it the same CRD file you have open? Likely is or I think the points would not get selected...