Double Click Settings for Blocks

Double Click Settings for Blocks

Postby Ewilson » Thu Nov 07, 2019 7:22 pm

In Intellicad 8 double clicking a block initiated the REFEDIT command but in Intellicad 9 that has been replaced with BEDIT. I was hoping I could revert this change in the CUI but there does not seem to be a definition for blocks. If anyone has discovered where this setting is hidden away it would be greatly appreciated.
Ewilson
 
Posts: 1
Joined: Thu Nov 07, 2019 4:26 pm
Location: Myrtle Beach

Return to IntelliCAD General

Who is online

Users browsing this forum: No registered users