DXF export - improper table entry name LEVEL 1

Moderator: Carlson Support

DXF export - improper table entry name LEVEL 1

Postby jdeitrick » Thu Mar 23, 2006 5:33 pm

Once all our data is collected for the day, we use the DXF export command
to capture the linework generated using the feature codes list (FCL). We
have been successfully doing this for some time, but now the following
error occurs when attempting to open (or insert into another drawing) the
exported DXF:

Improper table entry name LEVEL 1 on line 240.

Invalid or incomplete DXF input -- drawing discarded.

We are losing *a bit* of productivity as this was one of the reasons we
upgraded to SurvCE.

Any ideas?

Thanks,

Jim


##-----------------------------------------------##
Article posted with MyNewsGroups :)
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##
jdeitrick
 

Re: DXF export - improper table entry name LEVEL 1

Postby jdeitrick » Thu Mar 23, 2006 8:14 pm

Hey! I found the answer in the Knowledge Base, Topic ID:351. I should
have looked around some more...

Jim


jdeitrick wrote:



Once all our data is collected for the day, we use the DXF export
command
to capture the linework generated using the feature codes list (FCL).
We
have been successfully doing this for some time, but now the following
error occurs when attempting to open (or insert into another drawing)
the
exported DXF:

Improper table entry name LEVEL 1 on line 240.

Invalid or incomplete DXF input -- drawing discarded.

We are losing *a bit* of productivity as this was one of the reasons we
upgraded to SurvCE.

Any ideas?

Thanks,

Jim


##-----------------------------------------------##
Article posted with MyNewsGroups :)
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##






##-----------------------------------------------##
Article posted with MyNewsGroups :)
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survce
##-----------------------------------------------##
jdeitrick
 

Same Problem

Postby jeffmars1 » Wed Jun 18, 2008 8:17 pm

We are having the same problem with AutoCad Map Release 3 with LDD but the dxfix doesn't work for us in a project. Any other suggestions?
jeffmars1
 
Posts: 11
Joined: Wed Jun 18, 2008 7:08 pm
Location: Huntsville, ON


Return to SurvCE General

Who is online

Users browsing this forum: No registered users