Page 1 of 1
Copy, Clip & Move not working properly
Posted:
Tue Jun 30, 2015 7:32 pmby mark baker
I use Carlson 2013 embedded. A lot of time clip does not function property. Sometimes when I try to move or copy an object, it automatically throws my basepoint out in space (long distance from where I actually want). Any suggestions would be appreciated.
MB
Re: Copy, Clip & Move not working properly
Posted:
Sat Jul 25, 2015 10:24 pmby Gibbo
Do you use the paste using coordinates function?
Re: Copy, Clip & Move not working properly
Posted:
Sat Jul 25, 2015 10:51 pmby mark baker
No. When I use clipboard to copy to another drawing I use paste by coordinates. That function. In my original post I said clip but I guess I should have said trim.
Re: Copy, Clip & Move not working properly
Posted:
Sat Jul 25, 2015 10:53 pmby mark baker
The clipboard function works fine.
Re: Copy, Clip & Move not working properly
Posted:
Mon Jul 27, 2015 10:01 amby Gibbo
When using the Trim command check the options in the command line after you have selected your trimming object and type E for Edge. then E again for Extend. This may solve your problem. Also, the move or copy command will shift things to 0,0 if you click your right mouse button one too many times.
Re: Copy, Clip & Move not working properly
Posted:
Mon Jul 27, 2015 10:40 amby mark baker
Thanks so much. I really appreciate. I will try.
MB
Re: Copy, Clip & Move not working properly
Posted:
Mon Mar 25, 2019 1:52 pmby DiehlSurvey
Also you may want to try the EXTRIM command. It will trim everything inside or outside a Polyline