Page 1 of 1

Process raw data

PostPosted: Wed Oct 19, 2016 7:15 pm
This is my first go at processing raw data in Carlson. My DC has an export format of Carlson rw5 so that's the format im using... couldn't hurt.

I have it configured to angle right. Once opened in Carlson all my s/s appear to be angle right format but the angle sets for my traverse are showing azm.??? see attached.

Is this the norm, and if so should the code column drop down be changed to az. And if the data for the sets is azm and Carlson is expecting angle right then how is the graphic any where close to correct?

Re: Process raw data

PostPosted: Thu Dec 08, 2016 9:40 am
by JeffreyB
Good day. The flow of traffic in this forum is not ideal and you may wanna call Carlson Support; they are typically very helpful. There are couple crews at work that use Carlson DC and I will show them your question to see if they have an answer. Best of luck