Page 1 of 1
Defaults or Go By?
Posted:
Wed Jan 09, 2008 3:02 pm
by monksjm
Is there a place we can edit the default settings for things like layer naming or can you only change and save those settings?
Is there a "go-by" on project folder setup? Where things should be stored and what folders should be used and name?
Posted:
Thu Jan 10, 2008 3:09 am
by LNelson
For the editing/changing of things like layer names, try clicking:
Start --> Run. In the resulting dialog box, key-in:
%appdata%\Carlson Software\Carlson2008\R17.1\USER
I believe the files that contain things like layer names have *.INI extensions.
Also, you can toggle the "Skip Startup Wizard Next Time" via the Settings -- Carlson Configure -- General Settings. The location of files can be set via the Project/Data Folders button.
I hope this helps.
replies
Posted:
Thu Jan 10, 2008 1:09 pm
by monksjm
Thanks Ladd, i'll try those suggestions.
Posted:
Fri Jan 11, 2008 2:29 pm
by Jason
You might also try a template drawing for the layers. Get all the layers you want created and do file-save as and set the file type to drawing template. Then when you select file-new and it prompts for a template, select the one you created and all the layers will be ready to go.