Cul-de-sac cross sections

[ncwbruce]

Hello,

I have a cul-de-sac that I have created cross sections for during the Road Network processing. Unfortunately, I cannot tell where they lay in the plan view of the design. They start at station 0+00, then run for 282 feet or so. I don't seem to be able to have them plotted in the plan view like I can for the straight alignment sections. The cul-de-sac is an offset one, and the fillet starts at about 12+59 on my main alignment. Obviously, the 0+00 station must coorespond to some location. My first guess was this fillet location which is the end of the straight cross sections that are plotted. The cul-de-sac sections go at 10 foot intervals, with a scattering of off stations.

Any insite would be appreciated.

Thanks!

[site admin]

Have you got an answer on this yet? If not, please send an email to support@carlsonsw.com so we can take a look at it with you.