Nothing happens when trying to contour on a machine running Carlson and AutoCAD 2008. I have taken screen pictures of the settings used on a machine that can contour and nothing happens. Could be the result of a corrupt file during install?
Thanks
Dan Acord
Contour Won't Contour
Moderator: Carlson Support
5 posts
• Page 1 of 1
Contour Won't Contour
by Dan_Acord » Tue Oct 27, 2009 6:53 pm
- Dan_Acord
- Posts: 7
- Joined: Thu Nov 06, 2008 10:56 pm
- Location: Whitesville, WV
by site admin » Tue Nov 03, 2009 1:27 pm
please send a copy of the file and any other information that would help to support@carlsonsw.com for review. Thank you.
- site admin
- Site Admin
- Posts: 332
- Joined: Wed Nov 21, 2007 4:40 pm
- Location: Maysville KY
Contour won't contour
by earled » Tue Dec 15, 2009 10:13 pm
I am running Carlson 2009 in Autodesk Land Desktop 2006.
While I was editing crossing breaklines, Autocad crashed. The recovered file audits as fine, but will not contour. When I try to triangulate and contour, I can select inclusion and exclusion polylines and points and breaklines to contour, and the program reports how many elements were selected then locks up. Any suggestions?? Dan_Acord, was your problem solved?
While I was editing crossing breaklines, Autocad crashed. The recovered file audits as fine, but will not contour. When I try to triangulate and contour, I can select inclusion and exclusion polylines and points and breaklines to contour, and the program reports how many elements were selected then locks up. Any suggestions?? Dan_Acord, was your problem solved?
- earled
- Posts: 3
- Joined: Tue Dec 15, 2009 10:04 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users